Editing Naming convention

'''ShipConstructor Hull'''

EXPANSION DRAWINGS

Depending on the size and complexity of the project we distinguish 3 different levels in expansion drawings:

*Level 1	all curved plates in 1 drawing, all stringers in 1 drawing

**SHELL
**STRINGERS	expanded stringers


*Level 2	curved plates split in 2 drawings, stringers split in 2 drawings

**HULL				
**SUPERSTRUCTURE
**STRINGERS-HULL			expanded stringers hull
**STRINGERS-SUPERSTRUCTURE		expanded stringers superstructure		

*Level 3	curved plates and stringers split in several drawings

**HULL				
**BOTTOM
**SPRAYRAIL			
**SIDE
**RANSOM
**APPENDAGES				keels, shaft struts, etc.
**DECK		
**SUPERSTRUCTURE

'''ShipConstructor Structure'''

PLANAR GROUP NAMES

*Frame		
**FR02			full frame	
**FR02+050		intermediary frame at 50mm forward of frame 2

''NOTE'' distances are always measured positive, forward of a frame (except for F00)
Use 2 digits for frame number, 3 digits for intermediary distance


*Longitudinal	
**B0000G_C		longitudinal at centerline
**B0500P-LG01		portside longitudinal at 500mm from CL
**B0750S-LG03		starboard longitudinal at 750mm from CL
**B0200-0500P-LG05	skewed portisde longitudinal between B200 and B500

Use 4 digits for buttock distance, 2 digits for LG number	


*Deck
**W2500-DK01		deck at W2500 (2500mm above baseline)
**W0200-0500-DK03	skewed deck between W200 and W500

*Use 4 digits for waterline distance, 2 digits for DK number