Difference between revisions of "Differences between SC2005 and SC2011"
From NavykI
(New page: *In SC 2005 we mirror the longitudinal in unit, but in SC2011 we have to mirror in planar group. In this case we don't see good in approval. *In SC2011 when create a faceplate or stiffener...) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | *In SC 2005 we mirror the longitudinal in unit, but in SC2011 we have to mirror in planar group. In this case we don't see good in approval. | + | * In SC 2005 we mirror the longitudinal in unit, but in SC2011 we have to mirror in planar group. In this case we don't see good in approval. |
| − | *In SC2011 when create a faceplate or stiffener the piecemark is text 40, sometimes this piecemark exceeds the length of the faceplate. To solve this we edit the piecemark and set the size of the text smaller. | + | * In SC2011 when create a faceplate or stiffener the piecemark is text 40, sometimes this piecemark exceeds the length of the faceplate. To solve this we edit the piecemark and set the size of the text smaller. |
| − | *In SC2011 if expand the plates like in SC2005 we don't see good in nest(is not mirrored), in this case when expand the plate we leave it like SC2011 creates it. | + | * In SC2011 if expand the plates like in SC2005 we don't see good in nest(is not mirrored), in this case when expand the plate we leave it like SC2011 creates it. |
| + | * Export to NC-Pyros - linetype dashed is being exploded into short lines | ||
| + | * 09017-08 - export drawing cannot be created from curved plate group | ||
| + | * Parts marked far side are not inserted mirror wise into the nests | ||
| + | |||
| + | [[Category: Naval Architecture]] | ||
Latest revision as of 16:36, 30 November 2010
- In SC 2005 we mirror the longitudinal in unit, but in SC2011 we have to mirror in planar group. In this case we don't see good in approval.
- In SC2011 when create a faceplate or stiffener the piecemark is text 40, sometimes this piecemark exceeds the length of the faceplate. To solve this we edit the piecemark and set the size of the text smaller.
- In SC2011 if expand the plates like in SC2005 we don't see good in nest(is not mirrored), in this case when expand the plate we leave it like SC2011 creates it.
- Export to NC-Pyros - linetype dashed is being exploded into short lines
- 09017-08 - export drawing cannot be created from curved plate group
- Parts marked far side are not inserted mirror wise into the nests
