Difference between revisions of "CNC milling"
From NavykI
(→13012 Dykstra 62) |
Navykisysop (talk | contribs) |
||
(6 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
− | == 13012 Dykstra 62 == | + | == [[13012 Dykstra 62]] == |
*File ''13012 SY62 nest_Bulkheads rev_E.dwg'' (Bulkheads, relative simple) | *File ''13012 SY62 nest_Bulkheads rev_E.dwg'' (Bulkheads, relative simple) | ||
*Milled by [http://marronjachtbouw.nl Marron] | *Milled by [http://marronjachtbouw.nl Marron] | ||
Line 6: | Line 6: | ||
*Software > Maestro | *Software > Maestro | ||
*Router bit for outside contours > Ø8, 18.000 RPM, 6 meter/minute | *Router bit for outside contours > Ø8, 18.000 RPM, 6 meter/minute | ||
− | **less vacuum loss | + | **Arguments for small toolbit: |
− | **tool life is no issue for wood | + | ***less vacuum loss |
+ | ***tool life is no issue for wood | ||
*remarks | *remarks | ||
**in theory lines/arcs should not be smaller then radius of router bit | **in theory lines/arcs should not be smaller then radius of router bit | ||
− | **depending on software it will | + | **depending on software it will create problems or not |
− | **as test Mr. Ranga ran with | + | **as a test Mr. Ranga ran with Ø80 bit around contour with 9mm step in it without errors |
− | **lines/arcs should also be larger then machine displacement (depending on machine displacement the milling contours are divided in steps) | + | **lines/arcs should also be larger then machine displacement (depending on machine displacement the milling contours are divided in steps, can be adjusted in machine parameters) |
+ | |||
+ | == 15038 BV 45ST Pure == | ||
+ | *Milled by [http://www.cncwerk.nl/ CNC werk] | ||
+ | |||
+ | == 15057 Primaat 12m == | ||
+ | *Milled by [http://www.issos.nl/ Issos] | ||
+ | |||
+ | |||
+ | [[Category: Interior]] |
Latest revision as of 14:42, 28 December 2017
13012 Dykstra 62[edit]
- File 13012 SY62 nest_Bulkheads rev_E.dwg (Bulkheads, relative simple)
- Milled by Marron
- Programmer > Mr. Ranga, with a background in CNC micro processing of metal
- Software > Maestro
- Router bit for outside contours > Ø8, 18.000 RPM, 6 meter/minute
- Arguments for small toolbit:
- less vacuum loss
- tool life is no issue for wood
- Arguments for small toolbit:
- remarks
- in theory lines/arcs should not be smaller then radius of router bit
- depending on software it will create problems or not
- as a test Mr. Ranga ran with Ø80 bit around contour with 9mm step in it without errors
- lines/arcs should also be larger then machine displacement (depending on machine displacement the milling contours are divided in steps, can be adjusted in machine parameters)
15038 BV 45ST Pure[edit]
- Milled by CNC werk
15057 Primaat 12m[edit]
- Milled by Issos