Difference between revisions of "Issues SC2008"
From NavykI
(New page: == Hull == *minimum import tolerance is 0.1mm, how to increase? *trim lines in hull gives big differences because of NURBS lines are transformed into polylines == Structure == *CON layer...) |
|||
| Line 9: | Line 9: | ||
*unreconciled layers - what is the use? | *unreconciled layers - what is the use? | ||
**unreconciled layers are not plotted because SC switches them 'off', switch them on manually to plot the drawing | **unreconciled layers are not plotted because SC switches them 'off', switch them on manually to plot the drawing | ||
| + | *Export - how to export only the solid layers? | ||
[[Category: ShipConstructor]] | [[Category: ShipConstructor]] | ||
Revision as of 11:13, 3 September 2009
Hull
- minimum import tolerance is 0.1mm, how to increase?
- trim lines in hull gives big differences because of NURBS lines are transformed into polylines
Structure
- CON layer buttons must be made functional
- layer management (important for bound approval)
- unreconciled layers - what is the use?
- unreconciled layers are not plotted because SC switches them 'off', switch them on manually to plot the drawing
- Export - how to export only the solid layers?
