11016-01 Koopmans 46 - railing

General[edit]

workshop drawing for all stainless steel on deck
railing with pulpits removable for yacht transport over road (total combination should exceed 4m)

scepters Ø30x2
entry scepters as in GA
scepters with foot (plate 5mm), bolted trhough GRP into st.st. deckstringer
scepters with 6mm bracket at foot
consider:
- provisions for Furlex lines jib + genoa (consult designer?)
- lifeline

nav lights
lugs for railing wires
tube down extends through footplate and deck and st.st. deckstrip for cable passage
code zero:
- chainplate will be about 300mm in front chainplate forestay
- roller furling with Furlex X

principal as CB 38
radararch is combined with pulpit
arch tubes Ø35x2
horizontal middle tube Ø25x2
radararch to extend beyond transom for hoisting dinghy outboard engine
radararch incorporates biminitop, biminitop connects forward to sprayhood
swimladder on PS
swimladder with folding part of 2 steps below waterline
liferaft - Viking RescYou™ Pro for 6 person, in container with ISO pack I in grab bag
consider:
- GRP overlaps only 40mm the st.st. deckstrip (scepter mounting detail?)
- wind vane steering
- MOB buoy - orange life saving floating device is mandatory
- support for outboardengine of dinghy - NOT possible
- seat in the corners - NOT possible
- flagpole st.st. with hook on top, horizontal eye under, flag is fixed with flagloop on top, flagline passes through eye and is fixed around railing tube
- sternlight
- hinges of hatches aftseat (to not interfere with stanchions)
- tackle for lifting outboard engine onto dinghy
- second anchor? - NOT possible

emergency antenna VHF - the primary one will be GX2100E; he bought as a secondary one GX2150 Matrix AIS
radio antenna (AM/FM) - thinks that the antenna will be a standard one
GPS
spare antenna for combined radio receiver/AIS
cables have to pass via frame under deck
- tube to extend through footplate
- wind generator (Sutherland ?!) - CANCELED
- solar panels
  - inspiration model Sun Earth 250WP
- needs connections to hooks and ropes - eyes on the radar arch - IGNORE
NOTE: radar will be in mast

deck brackets for dinghy storage
2 fender supports on aft pulpit? Ø250? (6 in total, 4 stored in anchorlocker?) - fender supports - no space for them
windsteering control lines go to disc on Jefa pedestal?
mainsheet Ø13mm (important for correct rope clutch)

contact at Gebo is Wim Maaneman (export):
- T 0031 36 5211 233
- M 0031 610 162 307
- E wmaaneman@gebo.com
control lines have to pass through base
top of windscreen to be in 1 plane
mounting flange 16 or 37mm length?

Inspiration