Editing Flanges
From NavykI
Revision as of 16:51, 9 December 2009 by 192.168.11.14 (talk) (New page: Using a bend table which defines the correction factor between a range for thickness, radius and angle and interpolate between would make it much more flexible. See the example table below...)
Warning: You are editing an out-of-date revision of this page. If you save it, any changes made since this revision will be lost.
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.