Difference between revisions of "Issues ShipConstructor"

Revision as of 10:27, 15 March 2012

APPROVAL
- text placement - part text which has been dragged moves back to the old location after exploding the bound approval drawing
  - does not happen in nest drawings after preparing for CNC
- double lines - created by SC, how to get rid of them, is there a way via SC by means of a setting somewhere?
  - see Approval drawing
- leaders - mix up after binding the approval - possible solution: use 'middle of text' for left and right attachment
NEST
- finshes - many times they do not appear in the BOM
- nest template - BOM must be split in columns when 1 column becomes too long to fit on the page
  - table can be stretched from the bottom
HULL
- radiused cutout contours turn into chamfered cutout contours after expansion
  - see this for workaround [1]
- Attention to be paid when importing flat surfaces in hull from rhino. Changes in dimention may appear.
  - no solutions yet.

@@ Line 6: / Line 6: @@
 **double lines - created by SC, how to get rid of them, is there a way via SC by means of a setting somewhere?
 ***see [[Approval drawing]]
+**leaders - mix up after binding the approval - possible solution: use 'middle of text' for left and right attachment
 *NEST
+**finshes - many times they do not appear in the BOM
 **nest template - BOM must be split in columns when 1 column becomes too long to fit on the page
 ***table can be stretched from the bottom