Difference between revisions of "12024 Fish boat 700"

From NavykI
Jump to: navigation, search
(60 Systems)
(Classification)
Line 8: Line 8:
 
*CE category D  
 
*CE category D  
 
*bilge system - electrical only is allowed?
 
*bilge system - electrical only is allowed?
*fire protection - extinguisher
+
*fire protection - extinguisher(fire extinguisher shall be located within 1 m from the main helm position or the cockpit for boats with LH < 10 m)
 
*fire protection - extinguisher port in engine box
 
*fire protection - extinguisher port in engine box
 
*fuel system - shut down by means of ball valve operated by T-handle in dashboard (Exalto)
 
*fuel system - shut down by means of ball valve operated by T-handle in dashboard (Exalto)

Revision as of 15:44, 4 September 2012

General

Description

Contacts

Classification

  • CE category D
  • bilge system - electrical only is allowed?
  • fire protection - extinguisher(fire extinguisher shall be located within 1 m from the main helm position or the cockpit for boats with LH < 10 m)
  • fire protection - extinguisher port in engine box
  • fuel system - shut down by means of ball valve operated by T-handle in dashboard (Exalto)
  • steering system - emergency tiller

Scope

  • CE technical file €1000
    • English language only
    • excluding owner's manual

Drawing list

Time schedule

Questions

To do

10 General

  • LOA 700
  • BOA 240 (for trailering)
  • inboard diesel (20hp?)

40 Construction

  • keel - fill completely with a compound?
  • steel 5mm (no filler), bottom 8mm?
  • no frames/floors

50 Outfitting

  • rope fender around boat

60 Systems

  • Exhaust
    • exhaust - requires air vent (Vetus: minimum 400m above waterline)
    • exhaust - from engine box to transom stainless steel pipe
  • Bilge - from engine box to transom stainless steel pipe
    • ISO requirements for open deck or partially sheltered cat D:
      • It is the responsibility of the owner/operator to have at least one bailer/draw bucket on board, secured against accidental loss.
      • ISO recommends the use of a bilge pump(recommends only and does not mention the type)
      • capacity - 15 l/min for boats with LH greater than 6 m and less than 12 m
        • these volumes shall be achieved when the pump is subjected to a pressure of 10 kPa. For manual bilge pumps, the capacity shall be rated for 45 strokes per minute
      • no secondary bilge pump is required
  • Steering - hydraulic lines through keel stainless steel pipe
  • Fuel
    • fuel tank - PP custom made
    • fuel fill - filler cap directly on top of tank
    • fuel tank vent - hole in filler cap
    • fuel tank is allowed in the engine compartment
    • an air gap to prevent any contact between the tank and engine is required(unless an equivalent thermal barrier is provided) (ISO 9094-1)
      • 100 mm between a petrol engine and a fuel tank
      • 250 mm between a dry exhaust and a fuel tank

70 Interior

80 Paint

  • epoxy tar - hull and interior
  • deck - other colour