Difference between revisions of "11016-01 Koopmans 46 - railing"

Revision as of 09:49, 16 February 2012

General

• workshop drawing for all stainless steel on deck
• railing with pulpits removable for yacht transport over road (total combination should exceed 4m)

Railing

• scepters Ø30x2
• entry scepters as in GA
• scepters with foot (plate 4mm), bolted trhough GRP into st.st. deckstringer
• consider:
  • provisions for Furlex lines jib + genoa (consult designer?)
  • lifeline

Pulpit fore

• nav lights
• lugs for railing wires
• tube down extends through footplate and deck and st.st. deckstrip for cable passage

Pulpit aft / radararch

• principal as CB 38
• radararch is combined with pulpit
• arch tubes Ø35x2
• horizontal middle tube Ø25x2
• radararch to extend beyond transom for hoisting dinghy outboard engine
• radararch incorporates biminitop, biminitop connects forward to sprayhood
• swimladder on SB
• swimladder with folding part of 2 steps below waterline
• consider:
  • GRP overlaps only 40mm the st.st. deckstrip (scepter mounting detail?)
  • windsteering
  • MOB buoy
  • life raft
  • outboard for dinghy
  • wind vane steering (including (provisions for) lines to helm)
  • if possible a seat in the corners
  • flagpole st.st. with hook on top, horizontal eye under, flag is fixed with flagloop on top, flagline passes through eye and is fixed around railing tube
  • sternlight
  • hinges of hatches aftseat (to not interfere with stanchions)

Radararch

• (radar antenna)
• emergency antenna VHF
• radio antenna (AM/FM)
• GPS
• spare antenna for combined radio receiver/AIS (ask Atilla for brand)
• cables have to pass via frame under deck
  • consider thick radarcable
  • tube to extend through footplate
  • wind generator (Sutherland ?!)
  • solar panels

Miscellaneous

• deck brackets for dinghy storage
• 2 fender supports on aft pulpit? Ø250? (6 in total, 4 stored in anchorlocker?)
• windsteering control lines go to disc on Jefa pedestal?

Windscreen

• Gebo
• model in 3D?
• control lines have to pass through base
• top of windscreen to be in 1 plane

Sprayhood

• transfers from angled windscreen into round shape
• 2 frames/brackets

Inspiration

• http://www.tecsew.com/gallery/cockpit-enclosures
• http://www.radararch.ca/viewer.swf