12024 Fish boat 700

General

CE category D
bilge system - electrical only is allowed?
fire protection - extinguisher(fire extinguisher shall be located within 1 m from the main helm position or the cockpit for boats with LH < 10 m)
fire protection - extinguisher port in engine box
fuel system - shut down by means of ball valve operated by T-handle in dashboard (Exalto)
steering system - emergency tiller

engine: 4 cylinder Craftsman
add boardlights
add boarding ladder
required as soon as possible:
length shaft + tube (Ø30mm)
lenght rope fender
add oval portholes Gebo
rudder - purchase item from Allpa?
furthermore:
- frame for hood/tent required
- bottom covered with a rubber sheet (?)
- forepeak benches - wooden strips, give dimensions/expansions
- forepeak entrance door - 30mm PVC panel

Exhaust
- exhaust - requires air vent (Vetus: minimum 400m above waterline)
- exhaust - from engine box to transom stainless steel pipe
Bilge - from engine box to transom stainless steel pipe
- ISO requirements for open deck or partially sheltered cat D:
  - It is the responsibility of the owner/operator to have at least one bailer/draw bucket on board, secured against accidental loss.
  - ISO recommends the use of a bilge pump(recommends only and does not mention the type)
  - capacity - 15 l/min for boats with LH greater than 6 m and less than 12 m
    - these volumes shall be achieved when the pump is subjected to a pressure of 10 kPa. For manual bilge pumps, the capacity shall be rated for 45 strokes per minute
  - no secondary bilge pump is required
Steering - hydraulic lines through keel stainless steel pipe
Fuel
- fuel tank - PP custom made
- fuel fill - filler cap directly on top of tank
- fuel tank vent - hole in filler cap
- fuel tank is allowed in the engine compartment
- an air gap to prevent any contact between the tank and engine is required(unless an equivalent thermal barrier is provided) (ISO 9094-1)
  - 100 mm between a petrol engine and a fuel tank
  - 250 mm between a dry exhaust and a fuel tank