11016-01 Koopmans 46 - railing

From NavykI
Revision as of 10:49, 16 February 2012 by 192.168.11.23 (talk) (Sprayhood)

Jump to: navigation, search

General

  • workshop drawing for all stainless steel on deck
  • railing with pulpits removable for yacht transport over road (total combination should exceed 4m)

Railing

  • scepters Ø30x2
  • entry scepters as in GA
  • scepters with foot (plate 4mm), bolted trhough GRP into st.st. deckstringer
  • consider:
    • provisions for Furlex lines jib + genoa (consult designer?)
    • lifeline

Pulpit fore

  • nav lights
  • lugs for railing wires
  • tube down extends through footplate and deck and st.st. deckstrip for cable passage

Pulpit aft / radararch

  • principal as CB 38
  • radararch is combined with pulpit
  • arch tubes Ø35x2
  • horizontal middle tube Ø25x2
  • radararch to extend beyond transom for hoisting dinghy outboard engine
  • radararch incorporates biminitop, biminitop connects forward to sprayhood
  • swimladder on SB
  • swimladder with folding part of 2 steps below waterline
  • consider:
    • GRP overlaps only 40mm the st.st. deckstrip (scepter mounting detail?)
    • windsteering
    • MOB buoy
    • life raft
    • outboard for dinghy
    • wind vane steering (including (provisions for) lines to helm)
    • if possible a seat in the corners
    • flagpole st.st. with hook on top, horizontal eye under, flag is fixed with flagloop on top, flagline passes through eye and is fixed around railing tube
    • sternlight
    • hinges of hatches aftseat (to not interfere with stanchions)

Radararch

  • (radar antenna)
  • emergency antenna VHF
  • radio antenna (AM/FM)
  • GPS
  • spare antenna for combined radio receiver/AIS (ask Atilla for brand)
  • cables have to pass via frame under deck
    • consider thick radarcable
    • tube to extend through footplate
    • wind generator (Sutherland ?!)
    • solar panels

Miscellaneous

  • deck brackets for dinghy storage
  • 2 fender supports on aft pulpit? Ø250? (6 in total, 4 stored in anchorlocker?)
  • windsteering control lines go to disc on Jefa pedestal?

Windscreen

  • Gebo
  • model in 3D?
  • control lines have to pass through base
  • top of windscreen to be in 1 plane

Sprayhood

  • transfers from angled windscreen into round shape
  • 2 frames/brackets

Inspiration