11016-01 Koopmans 46 - railing
From NavykI
Contents
General
- workshop drawing for all stainless steel on deck
- railing with pulpits removable for yacht transport over road (total combination should exceed 4m)
Railing
- scepters Ø30x2
- entry scepters as in GA
- scepters with foot (plate 5mm), bolted trhough GRP into st.st. deckstringer
- scepters with 6mm bracket at foot
- consider:
- provisions for Furlex lines jib + genoa (consult designer?)
- lifeline
Pulpit fore
- nav lights
- lugs for railing wires
- tube down extends through footplate and deck and st.st. deckstrip for cable passage
- code zero:
- chainplate will be about 300mm in front chainplate forestay
- roller furling with Furlex X
Pulpit aft / radararch
- principal as CB 38
- radararch is combined with pulpit
- arch tubes Ø35x2
- horizontal middle tube Ø25x2
- radararch to extend beyond transom for hoisting dinghy outboard engine
- radararch incorporates biminitop, biminitop connects forward to sprayhood
- swimladder on SB
- swimladder with folding part of 2 steps below waterline
- consider:
- GRP overlaps only 40mm the st.st. deckstrip (scepter mounting detail?)
- windsteering
- MOB buoy - orange life saving floating device is mandatory
- life raft
- support for outboardengine of dinghy
- wind vane steering (including (provisions for) lines to helm)
- if possible a seat in the corners
- flagpole st.st. with hook on top, horizontal eye under, flag is fixed with flagloop on top, flagline passes through eye and is fixed around railing tube
- sternlight
- hinges of hatches aftseat (to not interfere with stanchions)
- tackle for lifting outboard engine onto dinghy
- second anchor? - doesn't think there will be space for it
Radararch
- emergency antenna VHF
- radio antenna (AM/FM)
- GPS
- spare antenna for combined radio receiver/AIS (ask Atilla for brand)
- cables have to pass via frame under deck
- consider thick radarcable
- tube to extend through footplate
- wind generator (Sutherland ?!)
- solar panels
Miscellaneous
- deck brackets for dinghy storage
- 2 fender supports on aft pulpit? Ø250? (6 in total, 4 stored in anchorlocker?) - fender supports - no space for them
- windsteering control lines go to disc on Jefa pedestal?
- mainsheet Ø13mm (important for correct rope clutch)
Windscreen
- contact at Gebo is Wim Maaneman (export):
- T 0031 36 5211 233
- M 0031 610 162 307
- E wmaaneman@gebo.com
- control lines have to pass through base
- top of windscreen to be in 1 plane
- mounting flange 16 or 37mm length?
Sprayhood
- transfers from angled windscreen into round shape
- 2 frames/brackets
Inspiration
